These instructions assume the reader is familiar with the basic operating procedures of NetWare 4.0, and the basic concepts of local area network. Before proceeding, Novell NetWare software must be is installed and operating.

Novell NetWare 4.x provides an automatic installer that may be used with the driver. To install, use the following steps.

1. Start the NetWare server and run the INSTALL utility with the following command:

LOAD INSTALL

2. From the initial menu in the Installer, select Driver Options.

3. From the next menu, select Configure Network Drivers.

4. To add the driver for the adapter, select the Load a Driver option from the menu at the bottom of the page. The system will display a list of drivers currently available on the hard disk.

5. Press the INS key to choose an unlisted driver.

6. Press the F3 key to select the location of the unlisted driver.

7. Insert the adapter disk (either CD-ROM or diskette) and enter the directory name, for example:

A:\4.XX\

8. The INSTALL program will then ask for various parameters and options. Enter the values appropriate for your network. Once the program is finished, the network will be visible via the adapter. The network traffic statistics may be observed via the NetWare MONITOR program.

Your PCI bus number can be determined by running your adapter's diagnostic program. See your ZNYX Adapter hardware installation documentation for more information.